Installing a Brick Paver Walkway or Refractory Fire Brick

The usage of Bricks or Pavers to create a sidewalk or patio matches a house in a way that is unequaled. In addition, installing a Brick or Paver pathway does not necessarily need a pro.

The key to installing a Brick or Paver Walkway is to first effectively prepare the area where the bricks/pavers are to be installed. In addition, string lines must be strung on each side of the walkway.
Once the area has actually been dug down, 3/4" gravel stone need to be laid in and tamped down securely. Then 2" of sand, or stone dust must be topped the gravel. Again the sand/stone dust need to be tamped down. Stone dust is chosen. The height in between the tamped down sand and the stringline need to equate to the thickness of the brick or paver.

Now that you have a steady base, position a 1" pipeline or ledger board the length of the sidewalk on either side of the pathway. Utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will create a level surface location to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the ready area. These strips will act as your pathway border and help to keep the integrity and shape of the sidewalk.

You can then begin to lay the bricks/pavers when this is done. There are many patterns you can lay. I especially like the Herring Bone pattern. The secret to laying the bricks/pavers is to guarantee that they interlock with each other. Constantly stagger nearby rows of bricks by 1/2 of a brick to interlock them. This will once again help keep the stability of the walkway.

Inevitably bricks/pavers will need to be cut or divided when building the pathway. Unless you want to buy or lease a pricey wetsaw, I would suggest acquiring a basic brick/paver splitter. It is essentially a chisel with a broad end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the spot where you wish to break the brick. Utilizing a hammer strike the butt end of the click here sculpt firmly. You may need to do this a couple of times. You may also get more info wish to turn the brick/paver over and strike the opposite of the brick utilizing the hammer and chisle. Within one or 2 strikes the brick/paver should break cleanly. If your walkway has curves you will need to buy/rent a wetsaw.

After setting up the bricks, develop the outdoors edges with extra sand, and then shovel in the topsoil and pack down firmly.
Spread stone dust over the new walkway and sweep into the fractures. This will complete the interlocking of the bricks and help to remove any weed growth.


In addition, setting up a Brick or Paver pathway does not always require a pro. The key to setting up a Brick or Paver Walkway is to first effectively prepare the area where the bricks/pavers are to be installed. Now that you have a stable base, place a 1" pipeline or ledger board the length of the walkway on either side of the sidewalk. These more info strips will act as your pathway border and assistance to keep the integrity and shape of the sidewalk. Undoubtedly bricks/pavers will need to be cut or divided when building the walkway.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments on “Installing a Brick Paver Walkway or Refractory Fire Brick”

Leave a Reply

Gravatar